Searched refs:initialize (Results 1 – 25 of 45) sorted by relevance
12
14 Added call to initialize debugger on startup.42 Added call to initialize 860 debugger.
28 and function fecmxc_initialize will try to initialize it.
33 1. Read from hardware in initialize() function34 2. Read from environment in net/eth.c after initialize()
9 which can initialize the DDR and get the complete bootloader copied to DDR.11 In addition to the above there could be some more methods to initialize the DDR
48 __led_init is called once to initialize the LED to CONFIG_STATUS_LED_STATE.
20 common/console.c in console_init_r() during bootup to initialize
7 and initialize the lane depends on the
4 * and also initialize before relocation.
31 * to initialize. 100ms should be plenty of time to finish
129 * to initialize. 100ms should be plenty of time to finish
288 initialize: in s35392a_rtc_reset()305 goto initialize; in s35392a_rtc_reset()
4 //# if it has previously been used with the function used to initialize x.24 @initialize:ocaml@
24 "kermit" script to automatically initialize the environment
18 initialize (put into idle state) I2C bus after soft reset.
16 FPGA peripheral bitstream is used to initialize FPGA IOs,
44 code is run -- that is, initialize the DRAM in lowlevel_init().
9 depending on the exact board and pin configurations will initialize another11 the secondary program loader (SPL). The SPL will initialize the system125 to initialize hardware that's normally done by SPL.
22 @initialize:python@
161 Use the DDR controller to auto initialize memory. If not enabled,
68 spl: could not initialize mmc. error: -19
245 initialize eth_device276 * MAC, read it and initialize dev->enetaddr with it306 The exact arguments needed to initialize your device are up to you. If you
615 initalise||initialize616 initalize||initialize623 initilize||initialize655 intialize||initialize
41 avb init <dev> - initialize avb 2.0 for <dev>
15 The API provides functions to initialize/deinitialize the31 The API provides functions to initialize/deinitialize the
267 ret = net->initialize(net, 0, 0); in setup()
Completed in 31 milliseconds