| /linux/drivers/net/wireless/ath/ath9k/ |
| A D | ar9003_eeprom.c | 570 CTL(60, 1), CTL(60, 1), CTL(60, 1), CTL(60, 1),
571 CTL(60, 1), CTL(60, 1), CTL(60, 1), CTL(60, 0),
576 CTL(60, 1), CTL(60, 1), CTL(60, 1), CTL(60, 1),
577 CTL(60, 1), CTL(60, 1), CTL(60, 1), CTL(60, 0),
582 CTL(60, 0), CTL(60, 1), CTL(60, 0), CTL(60, 1),
583 CTL(60, 1), CTL(60, 1), CTL(60, 1), CTL(60, 1),
588 CTL(60, 0), CTL(60, 1), CTL(60, 1), CTL(60, 0),
589 CTL(60, 1), CTL(60, 0), CTL(60, 0), CTL(60, 0),
594 CTL(60, 1), CTL(60, 1), CTL(60, 1), CTL(60, 0),
595 CTL(60, 0), CTL(60, 0), CTL(60, 0), CTL(60, 0),
[all …]
|
| /linux/sound/pci/lola/ |
| A D | lola_pcm.c | 64 lola_dsd_write(chip, str->dsd, CTL, in lola_stream_start()
75 lola_dsd_write(chip, str->dsd, CTL, in lola_stream_stop()
88 val = lola_dsd_read(chip, str->dsd, CTL); in wait_for_srst_clear()
163 lola_dsd_write(chip, str->dsd, CTL, LOLA_DSD_CTL_SRUN | in lola_sync_pause()
175 lola_dsd_write(chip, str->dsd, CTL, in lola_stream_reset()
179 lola_dsd_write(chip, str->dsd, CTL, LOLA_DSD_CTL_SRST); in lola_stream_reset()
443 lola_dsd_write(chip, str->dsd, CTL, in lola_setup_controller()
|
| A D | lola_proc.c | 186 lola_dsd_read(chip, i, CTL)); in lola_proc_regs_read()
|
| /linux/Documentation/devicetree/bindings/net/ |
| A D | micrel-ksz90x1.txt | 49 - rxdv-skew-ps : Skew control of RX CTL pad
51 - txen-skew-ps : Skew control of TX CTL pad
142 - rxdv-skew-ps : Skew control of RX CTL pad
143 - txen-skew-ps : Skew control of TX CTL pad
175 - rxdv-skew-psec : Skew control of RX CTL pad
176 - txen-skew-psec : Skew control of TX CTL pad
|
| /linux/drivers/char/xilinx_hwicap/ |
| A D | xilinx_hwicap.c | 126 .CTL = 5,
151 .CTL = 5,
176 .CTL = 5,
201 .CTL = 5,
|
| A D | xilinx_hwicap.h | 130 u32 CTL; member
|
| /linux/drivers/net/wan/ |
| A D | c101.c | 184 sca_out(0, MSCI1_OFFSET + CTL, port); /* RTS uses ch#2 output */ in c101_open()
206 sca_out(CTL_NORTS, MSCI1_OFFSET + CTL, port); in c101_close()
|
| A D | hd64570.h | 63 #define CTL 0x11 /* Control */ macro
|
| A D | hd64572.h | 64 #define CTL 0x130 /* Control reg */ macro
|
| A D | hd64572.c | 458 sca_out(CTL_IDLE | CTL_URCT | CTL_URSKP, msci + CTL, card); in sca_open()
|
| A D | hd64570.c | 501 sca_out(CTL_IDLE, msci + CTL, card); in sca_open()
|
| /linux/Documentation/devicetree/bindings/memory-controllers/fsl/ |
| A D | imx8m-ddrc.yaml | 36 Base address and size of DDRC CTL area.
|
| /linux/sound/soc/qcom/ |
| A D | lpass-lpaif-reg.h | 142 #define LPAIF_DMACTL_REG(v, chan, dir, dai_id) __LPAIF_DMA_REG(v, chan, dir, CTL, dai_id)
|
| /linux/Documentation/ABI/testing/ |
| A D | sysfs-bus-coresight-devices-etb10 | 66 is read directly from HW register CTL, 0x020.
|
| A D | sysfs-bus-coresight-devices-tmc | 54 is read directly from HW register CTL, 0x020.
|
| /linux/arch/arm/boot/dts/ |
| A D | intel-ixp42x-gateworks-gw2348.dts | 100 /* First register set is CMD second is CTL (notice it uses CS2) */
|
| A D | intel-ixp43x-gateworks-gw2358.dts | 116 /* First register set is CMD second is CTL */
|
| /linux/drivers/media/dvb-frontends/ |
| A D | bcm3510_priv.h | 29 u8 CTL :8; member
|
| A D | bcm3510.c | 745 v.TSTCTL_2e.CTL = 0; in bcm3510_init_cold()
|
| /linux/drivers/usb/gadget/udc/ |
| A D | atmel_usba_udc.c | 1435 epctrl = usba_ep_readl(ep, CTL); in usba_control_irq()
1622 epctrl = usba_ep_readl(ep, CTL); in usba_ep_irq()
1660 epctrl = usba_ep_readl(ep, CTL); in usba_ep_irq()
|
| /linux/drivers/net/wireless/broadcom/brcm80211/brcmfmac/ |
| A D | fwsignal.c | 981 brcmf_dbg(CTL, "rssi %d\n", rssi); in brcmf_fws_rssi_indicate()
1590 brcmf_dbg(CTL, "received: seq %d, timestamp %d\n", data[1], in brcmf_fws_dbg_seqnum_check()
|
| A D | sdio.c | 3271 brcmf_dbg(CTL, "resumed on rxctl frame, got %d expected %d\n", in brcmf_sdio_bus_rxctl()
3277 brcmf_dbg(CTL, "cancelled\n"); in brcmf_sdio_bus_rxctl()
3280 brcmf_dbg(CTL, "resumed for unknown reason?\n"); in brcmf_sdio_bus_rxctl()
|