| /linux/Documentation/devicetree/bindings/display/ |
| A D | mipi-dsi-bus.txt | 1 MIPI DSI (Display Serial Interface) busses
9 standard properties in the context of the DSI bus.
11 Each DSI host provides a DSI bus. The DSI host controller's node contains a
18 DSI host
22 a DSI host, the following properties apply to a node representing a DSI host.
39 DSI peripheral
72 Peripherals that support dual channel DSI
80 an input endpoint of the DSI peripheral.
87 - (1), (2) and (3) are examples of a DSI host and peripheral on the DSI bus
90 DSI host using of-graph bindings.
[all …]
|
| A D | truly,nt35597.txt | 1 Truly model NT35597 DSI display driver
18 for single DSI or Dual DSI
19 This should be low for dual DSI and high for single DSI mode
23 - port@0: DSI input port driven by master DSI
24 - port@1: DSI input port driven by secondary DSI
|
| A D | brcm,bcm2835-dsi0.yaml | 7 title: Broadcom VC4 (VideoCore4) DSI Controller
30 - description: The DSI PLL clock feeding the DSI analog PHY
31 - description: The DSI ESC clock
32 - description: The DSI pixel clock
43 # - description: The DSI byte clock for the PHY
44 # - description: The DSI DDR2 clock
45 # - description: The DSI DDR clock
|
| A D | dsi-controller.yaml | 7 title: Common Properties for DSI Display Panels
13 This document defines device tree properties common to DSI, Display
22 Notice: this binding concerns DSI panels connected directly to a master
23 without any intermediate port graph to the panel. Each DSI master
41 description: Panels connected to the DSI link
49 The virtual channel number of a DSI peripheral. Must be in the range
50 from 0 to 3, as DSI uses a 2-bit addressing scheme. Some DSI
59 another DSI host to drive the same peripheral. Hardware supporting
61 to be driven by the same clock. Only the DSI host instance
|
| A D | st,stm32-dsi.yaml | 7 title: STMicroelectronics STM32 DSI host controller
14 The STMicroelectronics STM32 DSI controller uses the Synopsys DesignWare MIPI-DSI host controller.
29 - description: DSI bus clock
58 DSI input port node, connected to the ltdc rgb output port.
63 DSI output port node, connected to a panel or a bridge input port"
|
| /linux/drivers/gpu/drm/bridge/ |
| A D | Kconfig | 20 tristate "Cadence DPI/DSI bridge"
78 tristate "Lontium LT8912B DSI/HDMI bridge"
94 tristate "Lontium LT9611 DSI/HDMI bridge"
108 tristate "Lontium LT9611UXC DSI/HDMI bridge"
191 MIPI DSI to eDP converter
235 tristate "TC358762 DSI/DPI bridge"
241 Toshiba TC358762 DSI/DPI bridge driver.
244 tristate "TC358764 DSI/LVDS bridge"
250 Toshiba TC358764 DSI/LVDS bridge driver.
262 tristate "Toshiba TC358768 MIPI DSI bridge"
[all …]
|
| /linux/Documentation/devicetree/bindings/display/bridge/ |
| A D | cdns,dsi.txt | 1 Cadence DSI bridge
4 The Cadence DSI bridge is a DPI to DSI bridge supporting up to 4 DSI lanes.
9 - interrupts: interrupt line connected to the DSI bridge.
10 - clocks: DSI bridge clocks.
18 - resets: DSI reset lines.
24 * port 0: this port is only needed if some of your DSI devices are
27 DSI virtual channel used by this device.
31 - one subnode per DSI device connected on the DSI bus. Each DSI device should
|
| A D | ti,sn65dsi83.yaml | 7 title: SN65DSI83 and SN65DSI84 DSI to LVDS bridge chip
13 Texas Instruments SN65DSI83 1x Single-link MIPI DSI
16 Texas Instruments SN65DSI84 1x Single-link MIPI DSI
42 description: Video port for MIPI DSI Channel-A input
51 description: array of physical DSI data lane indexes.
62 description: Video port for MIPI DSI Channel-B input
71 description: array of physical DSI data lane indexes.
|
| A D | intel,keembay-dsi.yaml | 27 - description: MIPI DSI clock
28 - description: MIPI DSI econfig clock
29 - description: MIPI DSI config clock
43 description: MIPI DSI input port.
47 description: DSI output port.
|
| A D | toshiba,tc358764.txt | 1 TC358764 MIPI-DSI to LVDS panel bridge
5 - reg: the virtual channel number of a DSI peripheral
13 0: DSI Input, not required, if the bridge is DSI controlled
|
| A D | chipone,icn6211.yaml | 7 title: Chipone ICN6211 MIPI-DSI to RGB Converter bridge
13 ICN6211 is MIPI-DSI to RGB Converter bridge from chipone.
15 It has a flexible configuration of MIPI DSI signal input and
25 description: virtual channel number of a DSI peripheral
46 Video port for MIPI DSI input
|
| A D | toshiba,tc358762.yaml | 7 title: Toshiba TC358762 MIPI DSI to MIPI DPI bridge
13 The TC358762 is bridge device which converts MIPI DSI to MIPI DPI.
22 description: virtual channel number of a DSI peripheral
34 Video port for MIPI DSI input
|
| A D | snps,dw-mipi-dsi.yaml | 7 title: Synopsys DesignWare MIPI DSI host controller
14 DSI host controller. It doesn't constitue a device tree binding specification
32 - description: DSI bus clock for either AHB and APB
59 description: DSI output node to panel.
|
| /linux/drivers/gpu/drm/msm/ |
| A D | Kconfig | 75 bool "Enable DSI support in MSM DRM driver"
81 Choose this option if you have a need for MIPI DSI connector
85 bool "Enable DSI 28nm PHY driver in MSM DRM"
89 Choose this option if the 28nm DSI PHY is used on the platform.
92 bool "Enable DSI 20nm PHY driver in MSM DRM"
96 Choose this option if the 20nm DSI PHY is used on the platform.
99 bool "Enable DSI 28nm 8960 PHY driver in MSM DRM"
111 Choose this option if DSI PHY on 8996 is used on the platform.
114 bool "Enable DSI 10nm PHY driver in MSM DRM (used by SDM845)"
118 Choose this option if DSI PHY on SDM845 is used on the platform.
[all …]
|
| /linux/Documentation/devicetree/bindings/display/panel/ |
| A D | sharp,lq101r1sx01.yaml | 13 This panel requires a dual-channel DSI host to operate. It supports two modes:
17 Each of the DSI channels controls a separate DSI peripheral. The peripheral
18 driven by the first link (DSI-LINK1), left or even, is considered the primary
20 to the peripheral driven by the second link (DSI-LINK2, right or odd).
22 Note that in video mode the DSI-LINK1 interface always provides the left/even
23 pixels and DSI-LINK2 always provides the right/odd pixels. In command mode it
42 phandle to the DSI peripheral on the secondary link. Note that the
43 presence of this property marks the containing node as DSI-LINK1
|
| A D | orisetech,otm8009a.yaml | 7 title: Orise Tech OTM8009A 3.97" 480x800 TFT LCD panel (MIPI-DSI video mode)
14 a MIPI-DSI video interface. Its backlight is managed through the DSI link.
25 description: DSI virtual channel
|
| A D | raspberrypi,7inch-touchscreen.yaml | 14 This DSI panel contains:
16 - TC358762 DSI->DPI bridge
17 - Atmel microcontroller on I2C for power sequencing the DSI bridge and
21 and this binding covers the DSI display parts but not its touch input.
|
| A D | panel-dsi-cm.yaml | 7 title: DSI command mode panels
14 This binding file is a collection of the DSI panels that
16 referenced via the optional backlight property, the DSI
33 - const: panel-dsi-cm # Generic DSI command mode panel compatible fallback
37 description: DSI virtual channel
|
| /linux/Documentation/devicetree/bindings/display/exynos/ |
| A D | exynos_dsim.txt | 1 Exynos MIPI DSI Master
11 - interrupts: should contain DSI interrupt
23 according to DSI host bindings (see MIPI DSI bindings [1])
24 - samsung,burst-clock-frequency: specifies DSI frequency in high-speed burst
26 - samsung,esc-clock-frequency: specifies DSI frequency in escape mode
32 Should contain DSI peripheral nodes (see MIPI DSI bindings [1]).
37 1: DSI output
|
| /linux/drivers/gpu/drm/panel/ |
| A D | Kconfig | 58 45NA WUXGA PANEL DSI Video Mode panel
61 tristate "Generic DSI command mode panels"
121 4-lane 800x1280 MIPI DSI panel.
276 tristate "Novatek NT36672A DSI panel"
361 (1080x1920) DSI panel.
370 720x1280 DSI video mode panel.
379 RB070D30 1024x600 DSI panel.
440 DSI.
458 S6E63M0 panel using DSI.
584 tristate "TDO TL070WSH30 DSI panel"
[all …]
|
| /linux/Documentation/devicetree/bindings/display/ti/ |
| A D | ti,omap5-dss.txt | 21 - DSS Submodules: RFBI, DSI, HDMI
59 DSI
66 - interrupts: the DSI interrupt line
68 - vdd-supply: power supply for DSI
73 - Video port for DSI output
74 - DSI controlled peripherals
76 DSI Endpoint required properties:
77 - lanes: list of pin numbers for the DSI lanes: CLK+, CLK-, DATA0+, DATA0-,
|
| A D | ti,omap4-dss.txt | 21 - DSS Submodules: RFBI, VENC, DSI, HDMI
78 DSI
85 - interrupts: the DSI interrupt line
87 - vdd-supply: power supply for DSI
92 - Video port for DSI output
93 - DSI controlled peripherals
95 DSI Endpoint required properties:
96 - lanes: list of pin numbers for the DSI lanes: CLK+, CLK-, DATA0+, DATA0-,
|
| A D | ti,omap3-dss.txt | 72 DSI
79 - interrupts: the DSI interrupt line
81 - vdd-supply: power supply for DSI
85 DSI Endpoint required properties:
86 - lanes: list of pin numbers for the DSI lanes: CLK+, CLK-, DATA0+, DATA0-,
|
| /linux/Documentation/devicetree/bindings/display/mediatek/ |
| A D | mediatek,dsi.txt | 1 Mediatek DSI Device
4 The Mediatek DSI function block is a sink of the display subsystem and can
5 drive up to 4-lane MIPI DSI output. Two DSIs can be synchronized for dual-
20 to the input port of an attached DSI panel or DSI-to-eDP encoder chip.
|
| /linux/Documentation/devicetree/bindings/phy/ |
| A D | mixel,mipi-dsi-phy.txt | 1 Mixel DSI PHY for i.MX8
3 The Mixel MIPI-DSI PHY IP block is e.g. found on i.MX8 platforms (along the
4 MIPI-DSI IP from Northwest Logic). It represents the physical layer for the
5 electrical signals for DSI.
|