| /linux/Documentation/devicetree/bindings/mfd/ |
| A D | aspeed-lpc.yaml | 8 title: Aspeed Low Pin Count (LPC) Bus Controller
15 The LPC bus is a means to bridge a host CPU to a number of low-bandwidth
17 primary use case of the Aspeed LPC controller is as a slave on the bus
21 The LPC controller is represented as a multi-function device to account for the
26 * An LPC Host Interface Controller manages functions exposed to the host such
27 as LPC firmware hub cycles, configuration of the LPC-to-AHB mapping, UART
34 Additionally the state of the LPC controller influences the pinmux
66 LPC firmware hub cycles, configuration of the LPC-to-AHB mapping, UART management
127 bytes written by the Host to the targeted LPC I/O pots.
145 description: The LPC I/O ports to snoop
[all …]
|
| /linux/Documentation/devicetree/bindings/rtc/ |
| A D | rtc-st-lpc.txt | 1 STMicroelectronics Low Power Controller (LPC) - RTC
4 LPC currently supports Watchdog OR Real Time Clock OR Clocksource
13 - reg : LPC registers base address + size
14 - interrupts : LPC interrupt line number and associated flags
15 - clocks : Clock used by LPC device (See: ../clock/clock-bindings.txt)
16 - st,lpc-mode : The LPC can run either one of three modes:
|
| /linux/Documentation/devicetree/bindings/timer/ |
| A D | st,stih407-lpc | 1 STMicroelectronics Low Power Controller (LPC) - Clocksource
4 LPC currently supports Watchdog OR Real Time Clock OR Clocksource
13 - reg : LPC registers base address + size
14 - interrupts : LPC interrupt line number and associated flags
15 - clocks : Clock used by LPC device (See: ../clock/clock-bindings.txt)
16 - st,lpc-mode : The LPC can run either one of three modes:
|
| /linux/Documentation/devicetree/bindings/watchdog/ |
| A D | st_lpc_wdt.txt | 1 STMicroelectronics Low Power Controller (LPC) - Watchdog
4 LPC currently supports Watchdog OR Real Time Clock OR Clocksource
13 - reg : LPC registers base address + size
14 - interrupts : LPC interrupt line number and associated flags
15 - clocks : Clock used by LPC device (See: ../clock/clock-bindings.txt)
16 - st,lpc-mode : The LPC can run either one of three modes:
|
| /linux/drivers/soc/aspeed/ |
| A D | Kconfig | 8 tristate "ASPEED LPC firmware cycle control"
13 Control LPC firmware cycle mappings through ioctl()s. The driver
15 host LPC read/write region can be buffered.
18 tristate "ASPEED LPC snoop support"
23 Provides a driver to control the LPC snoop interface which
25 the host to an arbitrary LPC I/O port.
|
| /linux/Documentation/ABI/stable/ |
| A D | sysfs-driver-aspeed-vuart | 5 will appear on the host <-> BMC LPC bus.
13 the UART will appear on the host <-> BMC LPC bus.
21 host via the BMC LPC bus.
|
| /linux/Documentation/devicetree/bindings/ipmi/ |
| A D | aspeed,ast2400-kcs-bmc.yaml | 14 interfaces on the LPC bus for in-band IPMI communication with their host.
48 The host CPU LPC IO data and status addresses for the device. For most
57 A 2-cell property expressing the LPC SerIRQ number and the interrupt
67 description: The LPC channel number in the controller
|
| /linux/drivers/net/ethernet/nxp/ |
| A D | Kconfig | 3 tristate "NXP ethernet MAC on LPC devices"
9 some NXP LPC devices. You can safely enable this option for LPC32xx
|
| /linux/drivers/mcb/ |
| A D | Kconfig | 33 tristate "LPC (non PCI) based MCB carrier"
37 This is a MCB carrier on a LPC or non PCI device.
|
| /linux/Documentation/devicetree/bindings/arm/hisilicon/ |
| A D | low-pin-count.yaml | 13 Hisilicon HiP06 SoCs implement a Low Pin Count (LPC) controller, which
17 LPC device node.
|
| /linux/arch/sh/kernel/cpu/sh4a/ |
| A D | setup-sh7757.c | 803 LPC, LPC5, LPC6, LPC7, LPC8, enumerator
868 INTC_VECT(LPC, 0xaa0), INTC_VECT(LPC, 0xac0),
869 INTC_VECT(LPC, 0xae0), INTC_VECT(LPC, 0xb00),
870 INTC_VECT(LPC, 0xb20),
966 0, DMAC8_11, 0, PECI0, LPC, FRT, 0, TMR45,
1066 { INT2PRI5, 0, 32, 8, { TMR45, 0, FRT, LPC } },
|
| /linux/Documentation/devicetree/bindings/security/tpm/ |
| A D | tpm_tis_mmio.txt | 5 this interface will be implemented over Intel's LPC bus.
|
| /linux/Documentation/devicetree/bindings/pinctrl/ |
| A D | aspeed,ast2600-pinctrl.yaml | 40 I3C6, JTAGM, LHPD, LHSIRQ, LPC, LPCHC, LPCPD, LPCPME, LPCSMI, LSIRQ,
66 LPC, LPCHC, LPCPD, LPCPME, LPCSMI, LSIRQ, MACLINK1, MACLINK2, MACLINK3,
|
| /linux/drivers/platform/chrome/ |
| A D | Kconfig | 112 tristate "ChromeOS Embedded Controller (LPC)"
116 over an LPC bus, including the LPC Microchip EC (MEC) variant.
|
| /linux/drivers/vfio/pci/ |
| A D | Kconfig | 42 and LPC bridge config space.
|
| /linux/Documentation/devicetree/bindings/serial/ |
| A D | 8250.yaml | 195 configured. One possible data source is the LPC/eSPI mode bit. Only
202 The VUART LPC address. Only applicable to aspeed,ast2500-vuart.
|
| /linux/Documentation/i2c/busses/ |
| A D | i2c-sis630.rst | 52 LPC Controller (rev 36)
|
| /linux/Documentation/core-api/ |
| A D | dma-isa-lpc.rst | 2 DMA with ISA and LPC devices
8 controller. Even though ISA is more or less dead today the LPC bus
|
| /linux/Documentation/devicetree/bindings/clock/ |
| A D | lpc1850-ccu.txt | 36 specific LPC part. Check the user manual for your specific part.
|
| A D | lpc1850-cgu.txt | 42 specific LPC part. Base clocks are numbered from 0 to 27.
|
| /linux/drivers/mtd/spi-nor/controllers/ |
| A D | Kconfig | 24 Enable support for the NXP LPC SPI Flash Interface controller.
|
| /linux/drivers/pinctrl/aspeed/ |
| A D | pinctrl-aspeed-g6.c | 1117 SIG_EXPR_LIST_DECL_SESG(AB7, LAD0, LPC, SIG_DESC_SET(SCU434, 16),
1123 SIG_EXPR_LIST_DECL_SESG(AB8, LAD1, LPC, SIG_DESC_SET(SCU434, 17),
1129 SIG_EXPR_LIST_DECL_SESG(AC8, LAD2, LPC, SIG_DESC_SET(SCU434, 18),
1135 SIG_EXPR_LIST_DECL_SESG(AC7, LAD3, LPC, SIG_DESC_SET(SCU434, 19),
1141 SIG_EXPR_LIST_DECL_SESG(AE7, LCLK, LPC, SIG_DESC_SET(SCU434, 20),
1147 SIG_EXPR_LIST_DECL_SESG(AF7, LFRAME, LPC, SIG_DESC_SET(SCU434, 21),
1161 SIG_EXPR_LIST_DECL_SESG(AD8, LPCRST, LPC, SIG_DESC_SET(SCU434, 23),
1166 FUNC_GROUP_DECL(LPC, AB7, AB8, AC8, AC7, AE7, AF7, AD8);
1967 ASPEED_PINCTRL_GROUP(LPC),
2206 ASPEED_PINCTRL_FUNC(LPC),
|
| /linux/arch/arm/boot/dts/ |
| A D | aspeed-g6-pinctrl.dtsi | 336 function = "LPC";
337 groups = "LPC";
|
| A D | gemini-dlink-dns-313.dts | 201 * Used by fan & G751, conflicts LPC,
|
| /linux/arch/arc/include/asm/ |
| A D | entry-arcv2.h | 57 ; 4. Auto save: (optional) r0-r11, blink, LPE,LPS,LPC, JLI,LDI,EI
|