| /linux/Documentation/devicetree/bindings/interconnect/ |
| A D | qcom,bcm-voter.yaml | 27 upon triggering. If not specified, then the AMC and WAKE sets wait for
31 WAKE/SLEEP TCSs are triggered when the RSC transitions between active and
34 In most cases, it's necessary to wait in both the AMC and WAKE sets to
|
| /linux/arch/powerpc/include/asm/ |
| A D | dbdma.h | 36 #define WAKE 0x1000 macro
103 out_le32(&((regs)->control), (ACTIVE|DEAD|WAKE|FLUSH|PAUSE|RUN)<<16);\
|
| /linux/drivers/net/ethernet/apple/ |
| A D | mace.c | 306 out_le32(&dma->control, (WAKE|FLUSH|PAUSE|RUN) << 16); in dbdma_reset()
472 out_le32(&rd->control, (RUN|PAUSE|FLUSH|WAKE) << 16); /* clear run bit */ in mace_open()
482 out_le32(&td->control, (RUN|PAUSE|FLUSH|WAKE) << 16); in mace_open()
510 rd->control = cpu_to_le32((RUN|PAUSE|FLUSH|WAKE) << 16); /* clear run bit */ in mace_close()
511 td->control = cpu_to_le32((RUN|PAUSE|FLUSH|WAKE) << 16); /* clear run bit */ in mace_close()
571 out_le32(&td->control, ((RUN|WAKE) << 16) + (RUN|WAKE)); in mace_xmit_start()
796 out_le32(&td->control, ((RUN|WAKE) << 16) + (RUN|WAKE)); in mace_interrupt()
978 out_le32(&rd->control, ((RUN|WAKE) << 16) | (RUN|WAKE)); in mace_rxdma_intr()
|
| A D | bmac.c | 182 DBDMA_SET(RUN|WAKE) | DBDMA_CLEAR(PAUSE|DEAD)); in dbdma_continue()
190 DBDMA_CLEAR(ACTIVE|DEAD|WAKE|FLUSH|PAUSE|RUN)); in dbdma_reset()
483 rd->control = cpu_to_le32(DBDMA_CLEAR(RUN|PAUSE|FLUSH|WAKE)); /* clear run bit */ in bmac_suspend()
484 td->control = cpu_to_le32(DBDMA_CLEAR(RUN|PAUSE|FLUSH|WAKE)); /* clear run bit */ in bmac_suspend()
1404 rd->control = cpu_to_le32(DBDMA_CLEAR(RUN|PAUSE|FLUSH|WAKE)); /* clear run bit */ in bmac_close()
1405 td->control = cpu_to_le32(DBDMA_CLEAR(RUN|PAUSE|FLUSH|WAKE)); /* clear run bit */ in bmac_close()
1494 out_le32(&td->control, DBDMA_CLEAR(RUN|PAUSE|FLUSH|WAKE|ACTIVE|DEAD)); in bmac_tx_timeout()
1500 out_le32(&rd->control, DBDMA_CLEAR(RUN|PAUSE|FLUSH|WAKE|ACTIVE|DEAD)); in bmac_tx_timeout()
1503 out_le32(&rd->control, DBDMA_SET(RUN|WAKE)); in bmac_tx_timeout()
|
| /linux/arch/arm/boot/dts/ |
| A D | sun8i-h2-plus-bananapi-m2-zero.dts | 242 "BT-UART-RTS", "BT-UART-CTS", "WL-WAKE-AP", "BT-WAKE-AP",
243 "BT-RST-N", "AP-WAKE-BT", "", "",
|
| A D | sun6i-a31s-sinovoip-bpi-m2.dts | 326 "WL-WAKE-HOST", "BT-WAKE_HOST", "BT-ENABLE",
|
| A D | imx28-tx28.dts | 536 MX28_PAD_ENET0_RXD2__GPIO_4_9 /* WAKE */
|
| /linux/Documentation/devicetree/bindings/input/ |
| A D | atmel,maxtouch.yaml | 66 The WAKE line is an active-low input that is used to wake up the touch
73 The WAKE pin can be connected in one of the following ways:
|
| /linux/sound/ppc/ |
| A D | pmac.c | 155 out_le32(&rec->dma->control, (RUN|WAKE|FLUSH|PAUSE) << 16); in snd_pmac_dma_stop()
263 snd_pmac_dma_run(rec, RUN|WAKE); in snd_pmac_pcm_trigger()
392 out_le32(&rec->dma->control, (RUN|PAUSE|FLUSH|WAKE) << 16); in snd_pmac_pcm_dead_xfer()
425 out_le32(&rec->dma->control, ((RUN|WAKE) << 16) + (RUN|WAKE)); in snd_pmac_pcm_dead_xfer()
710 out_le32(&chip->playback.dma->control, (RUN|PAUSE|FLUSH|WAKE|DEAD) << 16); in snd_pmac_dbdma_reset()
712 out_le32(&chip->capture.dma->control, (RUN|PAUSE|FLUSH|WAKE|DEAD) << 16); in snd_pmac_dbdma_reset()
|
| /linux/arch/arm64/boot/dts/amlogic/ |
| A D | meson-gxl-s905x-khadas-vim.dts | 197 "WIFI Power Enable", "WIFI WAKE HOST",
203 "Bluetooth WAKE HOST",
|
| A D | meson-gxbb-nanopi-k2.dts | 283 "WIFI Power Enable", "WIFI WAKE HOST",
289 "Bluetooth WAKE HOST", "",
|
| /linux/tools/perf/trace/beauty/ |
| A D | futex_op.c | 39 P_FUTEX_OP(WAKE); arg->mask |= SCF_VAL3|SCF_UADDR2|SCF_TIMEOUT; break; in syscall_arg__scnprintf_futex_op()
|
| /linux/Documentation/devicetree/bindings/rtc/ |
| A D | rtc-omap.txt | 7 This RTC IP has special WAKE-EN Register to enable
|
| /linux/Documentation/driver-api/ |
| A D | hsi.rst | 16 signals and an additional READY signal for flow control. An additional WAKE
|
| /linux/drivers/scsi/ |
| A D | mac53c94.c | 112 writel((RUN|PAUSE|FLUSH|WAKE) << 16, &dma->control); in DEF_SCSI_QCMD()
138 writel((RUN|PAUSE|FLUSH|WAKE) << 16, &dma->control); in mac53c94_init()
|
| A D | mesh.c | 358 out_le32(&md->control, (RUN|PAUSE|FLUSH|WAKE) << 16); /* stop dma */ in mesh_init()
1713 out_le32(&md->control, (RUN|PAUSE|FLUSH|WAKE) << 16); /* stop dma */ in mesh_host_reset()
|
| /linux/Documentation/devicetree/bindings/pci/ |
| A D | qcom,pcie-ep.yaml | 81 description: GPIO used as WAKE# output signal
|
| /linux/drivers/pinctrl/nomadik/ |
| A D | pinctrl-nomadik.c | 621 WAKE, enumerator
675 __nmk_gpio_irq_modify(nmk_chip, offset, WAKE, on); in __nmk_gpio_set_wake()
763 __nmk_gpio_irq_modify(nmk_chip, d->hwirq, WAKE, false); in nmk_gpio_irq_set_type()
777 __nmk_gpio_irq_modify(nmk_chip, d->hwirq, WAKE, true); in nmk_gpio_irq_set_type()
|
| /linux/Documentation/devicetree/bindings/soc/qcom/ |
| A D | rpmh-rsc.txt | 21 WAKE /* Triggered by F/W */
|
| /linux/arch/arm64/boot/dts/allwinner/ |
| A D | sun50i-a64-amarula-relic.dts | 150 interrupts = <0 3 IRQ_TYPE_LEVEL_LOW>; /* WL-WAKE-AP: PL3 */
|
| /linux/drivers/ata/ |
| A D | pata_macio.c | 584 writel((RUN|PAUSE|FLUSH|WAKE|DEAD) << 16, &dma_regs->control); in pata_macio_freeze()
645 writel (((RUN|WAKE|DEAD) << 16), &dma_regs->control); in pata_macio_bmdma_stop()
|
| /linux/Documentation/networking/ |
| A D | can_ucan_protocol.rst | 154 UCAN_SLEEP/WAKE
|
| /linux/Documentation/hid/ |
| A D | intel-ish-hid.rst | 283 | | |-----WAKE UP------------------>|
|
| /linux/arch/powerpc/platforms/powermac/ |
| A D | feature.c | 514 out_le32(&chan->control, (ACTIVE|DEAD|WAKE|FLUSH|PAUSE|RUN)<<16); in dbdma_restore()
|
| /linux/Documentation/ |
| A D | memory-barriers.txt | 2120 SLEEP AND WAKE-UP FUNCTIONS
|