| /linux/Documentation/ABI/stable/ |
| A D | sysfs-firmware-opal-elog | 24 entries, read them out and acknowledge them.
27 entries than firmware can, so after you acknowledge
55 acknowledge: Writing 'ack' to this file will acknowledge
61 operations (currently just acknowledge).
|
| A D | sysfs-firmware-opal-dump | 39 acknowledge: When 'ack' is written to this, we will
40 acknowledge that we've retrieved the
|
| /linux/Documentation/devicetree/bindings/mailbox/ |
| A D | hisilicon,hi6220-mailbox.txt | 27 mailbox driver uses it to acknowledge interrupt
36 flag" mode or IRQ generated mode to acknowledge a TX
|
| /linux/Documentation/devicetree/bindings/dma/ |
| A D | st,stm32-mdma.yaml | 47 4. A 32bit value specifying the register to be used to acknowledge the request
49 5. A 32bit mask specifying the value to be written to acknowledge the request
|
| A D | st,stm32-dma.yaml | 43 -bit 4: alternative DMA request/acknowledge protocol
|
| /linux/Documentation/driver-api/ |
| A D | connector.rst | 73 acknowledge number. The sequence number may be copied into
80 acknowledge number MUST be the same + 1.
85 acknowledge is not equal to the sequence number in the original
|
| /linux/net/nfc/nci/ |
| A D | spi.c | 146 static int send_acknowledge(struct nci_spi *nspi, u8 acknowledge) in send_acknowledge() argument
159 hdr[2] = acknowledge << NCI_SPI_ACK_SHIFT; in send_acknowledge()
|
| /linux/Documentation/ |
| A D | COPYING-logo | 4 and is freely usable as long as you acknowledge Larry as the original
|
| /linux/drivers/staging/unisys/Documentation/ABI/ |
| A D | sysfs-platform-visorchipset | 68 The parahotplug/deviceenabled interface is used to acknowledge
87 The parahotplug/devicedisaabled interface is used to acknowledge
|
| /linux/Documentation/devicetree/bindings/remoteproc/ |
| A D | qcom,adsp.yaml | 286 - description: Stop acknowledge interrupt
314 - description: Stop acknowledge interrupt
315 - description: Shutdown acknowledge interrupt
|
| /linux/drivers/net/arcnet/ |
| A D | Kconfig | 59 acknowledge back to userspace. After the initial protocol byte every
64 0=no hardware acknowledge
|
| /linux/arch/powerpc/kernel/ |
| A D | prom_init.c | 2132 unsigned long *acknowledge in prom_hold_cpus() local
2152 (unsigned long)acknowledge); in prom_hold_cpus()
2153 prom_debug(" 1) *acknowledge = 0x%lx\n", *acknowledge); in prom_hold_cpus()
2188 *acknowledge = (unsigned long)-1; in prom_hold_cpus()
2197 (*acknowledge == ((unsigned long)-1)); i++ ) in prom_hold_cpus()
2200 if (*acknowledge == cpu_no) in prom_hold_cpus()
2203 prom_printf("failed: %lx\n", *acknowledge); in prom_hold_cpus()
|
| /linux/Documentation/arm/ |
| A D | interrupts.rst | 154 acknowledge the SA1110 IRQ each time you re-read the SA1111 IRQ status.
157 (eg, SMC9196), the handler must mask or acknowledge the parent IRQ
|
| /linux/arch/powerpc/boot/dts/ |
| A D | amigaone.dts | 51 8259-interrupt-acknowledge = <0xfef00000>;
|
| A D | mvme5100.dts | 93 8259-interrupt-acknowledge = <0xfeff0030>;
|
| /linux/Documentation/w1/ |
| A D | w1-netlink.rst | 187 Each message also includes sequence and acknowledge numbers.
192 acknowledge number is set to seq+1.
|
| /linux/Documentation/devicetree/bindings/i2c/ |
| A D | renesas,rmobile-iic.yaml | 108 - description: Non-acknowledge Detection Interrupt (TACKI)
|
| /linux/arch/powerpc/platforms/powernv/ |
| A D | opal-elog.c | 91 __ATTR(acknowledge, 0660, elog_ack_show, elog_ack_store);
|
| A D | opal-dump.c | 111 __ATTR(acknowledge, 0660, dump_ack_show, dump_ack_store);
|
| /linux/Documentation/networking/device_drivers/cellular/qualcomm/ |
| A D | rmnet.rst | 174 1 is to acknowledge the receipt of a command
|
| /linux/drivers/infiniband/sw/rxe/ |
| A D | rxe_resp.c | 996 static enum resp_states acknowledge(struct rxe_qp *qp, in acknowledge() function
1257 state = acknowledge(qp, pkt); in rxe_responder()
|
| /linux/Documentation/driver-api/surface_aggregator/ |
| A D | ssh.rst | 120 - Sent to acknowledge receival of |DATA| frame.
142 |DATA_SEQ|-type frame, the receiving party has to acknowledge receival of
|
| /linux/Documentation/usb/ |
| A D | CREDITS | 98 way to acknowledge the importance of Linux and to allow
|
| /linux/drivers/base/firmware_loader/ |
| A D | Kconfig | 92 acknowledge failure to find firmware as the timeout for the fallback
|
| /linux/drivers/net/wireless/marvell/mwifiex/ |
| A D | README | 239 acknowledge required) when GPIO is used to wakeup host.
|