Searched refs:dcon (Results 1 – 8 of 8) sorted by relevance
| /linux/drivers/staging/olpc_dcon/ |
| A D | olpc_dcon.c | 99 dcon_write(dcon, DCON_REG_MODE, dcon->disp_mode); in dcon_hw_init()
158 dcon_write(dcon, DCON_REG_BRIGHT, dcon->bl_val); in dcon_set_backlight()
163 dcon_write(dcon, DCON_REG_MODE, dcon->disp_mode); in dcon_set_backlight()
166 dcon_write(dcon, DCON_REG_MODE, dcon->disp_mode); in dcon_set_backlight()
186 dcon_write(dcon, DCON_REG_MODE, dcon->disp_mode); in dcon_set_mono_mode()
225 dcon_set_backlight(dcon, dcon->bl_val); in dcon_sleep()
294 wait_event_timeout(dcon->waitq, dcon->switched, HZ); in dcon_source_switch()
558 if (!dcon || !dcon->client) in dcon_reboot_notify()
593 dcon = kzalloc(sizeof(*dcon), GFP_KERNEL); in dcon_probe()
594 if (!dcon) in dcon_probe()
[all …]
|
| A D | olpc_dcon_xo_1_5.c | 86 static int dcon_init_xo_1_5(struct dcon_priv *dcon) in dcon_init_xo_1_5() argument
94 gpios_table.dev_id = dev_name(&dcon->client->dev); in dcon_init_xo_1_5()
99 gpios[i] = devm_gpiod_get(&dcon->client->dev, pin[i].name, in dcon_init_xo_1_5()
116 dcon->curr_src = (inl(VX855_GENL_PURPOSE_OUTPUT) & 0x1000) ? in dcon_init_xo_1_5()
118 dcon->pending_src = dcon->curr_src; in dcon_init_xo_1_5()
122 if (request_irq(irq, &dcon_interrupt, IRQF_SHARED, "DCON", dcon)) { in dcon_init_xo_1_5()
|
| A D | olpc_dcon_xo_1.c | 39 static int dcon_init_xo_1(struct dcon_priv *dcon) in dcon_init_xo_1() argument
46 gpios[i] = devm_gpiod_get(&dcon->client->dev, pin[i].name, in dcon_init_xo_1()
69 dcon->curr_src = cs5535_gpio_isset(OLPC_GPIO_DCON_LOAD, GPIO_OUTPUT_VAL) in dcon_init_xo_1()
72 dcon->pending_src = dcon->curr_src; in dcon_init_xo_1()
80 dcon->curr_src == DCON_SOURCE_CPU); in dcon_init_xo_1()
96 if (request_irq(DCON_IRQ, &dcon_interrupt, 0, "DCON", dcon)) { in dcon_init_xo_1()
|
| A D | Makefile | 2 olpc-dcon-objs += olpc_dcon.o olpc_dcon_xo_1.o olpc_dcon_xo_1_5.o
3 obj-$(CONFIG_FB_OLPC_DCON) += olpc-dcon.o
|
| A D | TODO | 5 2. The dcon low-power display mode can then be integrated using the
|
| A D | olpc_dcon.h | 94 int (*init)(struct dcon_priv *dcon);
|
| /linux/drivers/dma/ |
| A D | s3c24xx-dma.c | 173 u32 dcon; member
446 u32 dcon = txd->dcon; in s3c24xx_dma_start_next_sg() local
476 dcon |= S3C24XX_DCON_HWTRIG; in s3c24xx_dma_start_next_sg()
909 txd->dcon |= S3C24XX_DCON_HANDSHAKE; in s3c24xx_dma_prep_dma_cyclic()
913 txd->dcon |= S3C24XX_DCON_SYNC_PCLK; in s3c24xx_dma_prep_dma_cyclic()
917 txd->dcon |= S3C24XX_DCON_SYNC_HCLK; in s3c24xx_dma_prep_dma_cyclic()
932 txd->dcon |= S3C24XX_DCON_SERV_SINGLE; in s3c24xx_dma_prep_dma_cyclic()
998 txd->dcon |= S3C24XX_DCON_HANDSHAKE; in s3c24xx_dma_prep_slave_sg()
1002 txd->dcon |= S3C24XX_DCON_SYNC_PCLK; in s3c24xx_dma_prep_slave_sg()
1006 txd->dcon |= S3C24XX_DCON_SYNC_HCLK; in s3c24xx_dma_prep_slave_sg()
[all …]
|
| /linux/drivers/mmc/host/ |
| A D | s3cmci.c | 950 u32 dcon, imsk, stoptries = 3; in s3cmci_setup_data() local
981 dcon |= S3C2410_SDIDCON_DMAEN; in s3cmci_setup_data()
984 dcon |= S3C2410_SDIDCON_WIDEBUS; in s3cmci_setup_data()
986 dcon |= S3C2410_SDIDCON_BLOCKMODE; in s3cmci_setup_data()
989 dcon |= S3C2410_SDIDCON_TXAFTERRESP; in s3cmci_setup_data()
990 dcon |= S3C2410_SDIDCON_XFER_TXSTART; in s3cmci_setup_data()
994 dcon |= S3C2410_SDIDCON_RXAFTERCMD; in s3cmci_setup_data()
995 dcon |= S3C2410_SDIDCON_XFER_RXSTART; in s3cmci_setup_data()
999 dcon |= S3C2440_SDIDCON_DS_WORD; in s3cmci_setup_data()
1000 dcon |= S3C2440_SDIDCON_DATSTART; in s3cmci_setup_data()
[all …]
|
Completed in 17 milliseconds