Home
last modified time | relevance | path

Searched refs:temperature (Results 1 – 25 of 742) sorted by relevance

12345678910>>...30

/linux/Documentation/hwmon/
A Dmax1668.rst34 temp1_input ro local (ambient) temperature
35 temp1_max rw local temperature maximum threshold for alarm
36 temp1_max_alarm ro local temperature maximum threshold alarm
37 temp1_min rw local temperature minimum threshold for alarm
38 temp1_min_alarm ro local temperature minimum threshold alarm
39 temp2_input ro remote temperature 1
41 temp2_max_alarm ro remote temperature 1 maximum threshold alarm
43 temp2_min_alarm ro remote temperature 1 minimum threshold alarm
44 temp3_input ro remote temperature 2
54 temp4_input ro remote temperature 3
[all …]
A Ddrivetemp.rst23 This driver supports reporting the temperature of disk and solid state
24 drives with temperature sensors.
27 the current drive temperature and, if available, temperature limits
30 the drive temperature.
59 temp1_input Current drive temperature
61 this temperature may cause physical damage to the
64 temp1_max Maximum recommended continuous operating temperature
65 temp1_crit Maximum temperature limit. Operating the device above
66 this temperature may cause physical damage to the
68 temp1_lowest Minimum temperature seen this power cycle
[all …]
A Dnct6775.rst129 predefined temperature range. If the temperature goes out of range, fan
166 Secondary temperature source. Value is temperature
168 Set to 0 to disable secondary temperature control.
191 If the temperature is in the range defined by:
194 Target temperature, unit millidegree Celsius
207 when the temperature is above defined range.
243 controlled by setting the pwm and temperature attributes. When the temperature
252 temperature range.
261 Temperature tolerance for critical temperature,
275 temperature measurement device. As a result, the temperature reported on CPUTIN
[all …]
A Dmax6639.rst23 temperature and one external diode-connected transistor or two external
35 temp1_max RW Set THERM temperature for input 1
37 temp2_max RW Set THERM temperature for input 2
38 temp1_crit RW Set ALERT temperature for input 1
39 temp2_crit RW Set ALERT temperature for input 2
40 temp1_emergency RW Set OT temperature for input 1
42 temp2_emergency RW Set OT temperature for input 2
49 temp1_max_alarm R Alarm on THERM temperature on channel 1
50 temp2_max_alarm R Alarm on THERM temperature on channel 2
53 temp1_emergency_alarm R Alarm on OT temperature on channel 1
[all …]
A Dadt7410.rst50 The ADT7310/ADT7410 is a temperature sensor with rated temperature range of
59 continuous temperature sampling, as well as sampling one temperature value per
84 temp#_input temperature input
85 temp#_min temperature minimum setpoint
86 temp#_max temperature maximum setpoint
87 temp#_crit critical temperature setpoint
88 temp#_min_hyst hysteresis for temperature minimum (read-only)
89 temp#_max_hyst hysteresis for temperature maximum (read/write)
91 temp#_min_alarm temperature minimum alarm flag
92 temp#_max_alarm temperature maximum alarm flag
[all …]
A Damc6821.rst29 temp1_input ro on-chip temperature
37 temp2_input ro remote temperature
54 by remote temperature, 3=fan controlled by
55 combination of the on-chip temperature and
56 remote-sensor temperature,
59 temperature channels.
63 temperature channels.
68 range. Below this temperature
81 it defines the passive cooling temperature.
82 Below this temperature the fan stops in
[all …]
A Dk8temp.rst21 This driver permits reading temperature sensor(s) embedded inside AMD K8
29 There can be up to four temperature sensors inside single CPU. The driver
36 temp1_input temperature of Core 0 and "place" 0
37 temp2_input temperature of Core 0 and "place" 1
38 temp3_input temperature of Core 1 and "place" 0
39 temp4_input temperature of Core 1 and "place" 1
44 temperature is updated once a second. Valid temperatures are from -49 to
48 This temperature is defined as temperature between heat-spreader and CPU
50 There is no easy way how to measure the temperature which will correlate
51 with TCaseMax temperature.
[all …]
A Dmax6697.rst73 This driver implements support for several MAX6697 compatible temperature sensor
74 chips. The chips support one local temperature sensor plus four, six, or seven
75 remote temperature sensors. Remote temperature sensors are diode-connected
77 thermal transistors plus three thermistors in addition to the local temperature
81 temperature, temp[2..n] are remote temperatures. The actually supported
85 tempX_input RO temperature
86 tempX_max RW temperature maximum threshold
87 tempX_max_alarm RO temperature maximum threshold alarm
88 tempX_crit RW temperature critical threshold
89 tempX_crit_alarm RO temperature critical threshold alarm
[all …]
A Dmax16601.rst112 temp1_input VCORE temperature.
113 temp1_crit Critical high temperature.
115 temp1_max Maximum temperature.
116 temp1_max_alarm Chip temperature high alarm.
118 temp2_input TSENSE_0 temperature
119 temp3_input TSENSE_1 temperature
120 temp4_input TSENSE_2 temperature
121 temp5_input TSENSE_3 temperature
123 temp6_input VSA temperature.
124 temp6_crit Critical high temperature.
[all …]
A Dltc2947.rst22 voltage, power, temperature, charge and energy. The device supports both SPI
82 temp1_min Low temperature threshold
83 temp1_max High temperature threshold
84 temp1_input_lowest Historical minimum temperature use
85 temp1_input_highest Historical maximum temperature use
87 temp1_min_alarm Low temperature alarm
88 temp1_max_alarm High temperature alarm
91 temp2_min Low temperature threshold for fan control
92 temp2_max High temperature threshold for fan control
93 temp2_min_alarm Low temperature fan control alarm
[all …]
A Dlm83.rst29 The LM83 is a digital temperature sensor. It senses its own temperature as
30 well as the temperature of up to three external diodes. The LM82 is
34 in that the later can only sense the temperature of one external diode.
64 Most motherboards come with more than just temperature sensors for
66 sensors. This means that temperature-only chips are usually used as
69 temperature sensors (motherboard, processor, power supply) and primary
75 because you want an additional temperature sensor for each additional
80 (actually measuring the LM83's own temperature), one is used for the
81 CPU. The two other sensors must be used to measure the temperature of
85 All temperature values are given in degrees Celsius. Local temperature
[all …]
A Dw83627ehf.rst94 source differs from the temperature sources of the already reported temperature
102 it stays on until the temperature falls below the hysteresis value.
118 predefined temperature range. If the temperature goes out of range, fan
144 this file controls mode of fan/temperature control:
172 If the temperature is in the range defined by:
175 set target temperature, unit millidegree Celsius
185 minimum fan speed (range 1 - 255), when the temperature
189 corresponding fan off. (when the temperature was below
198 maximum fan speed (range 1 - 255), when the temperature
220 and 6, including extending the temperature input
[all …]
A Dk10temp.rst90 This driver permits reading of the internal temperature sensor of AMD
103 For CPUs older than Family 17h, there is one temperature measurement value,
108 Tctl is the processor temperature control value, used by the platform to
109 control cooling systems. Tctl is a non-physical temperature on an
111 physical temperature like die or case temperature. Instead, it specifies
112 the processor temperature relative to the point at which the system must
114 temperature and maximum thermal power dissipation.
118 If the BIOS has enabled hardware temperature control, the threshold at
123 the reported temperature (Tctl). Tdie is the real measured temperature, and
128 Models from 17h family report relative temperature, the driver aims to
[all …]
A Dw83792d.rst44 The driver implements three temperature sensors, seven fan rotation speed
61 on until the temperature falls below the Hysteresis value.
150 with the temperature varying. Three conditions may occur:
152 (1) If the temperature still exceeds the high limit, PWM duty
155 (2) If the temperature goes below the high limit, but still above the low
157 the temperature is in the target range.
160 slowly to 0 or a preset stop value until the temperature exceeds the low
167 available. When related temperature sensors detects the temperature in preset
181 - this file controls mode of fan/temperature control:
193 - Selects the desired temperature for cruise (degC)
[all …]
A Dmax6642.rst23 The MAX6642 is a digital temperature sensor. It senses its own temperature as
24 well as the temperature on one external diode.
26 All temperature values are given in degrees Celsius. Resolution
27 is 0.25 degree for the local temperature and for the remote temperature.
/linux/arch/arm64/boot/dts/exynos/
A Dexynos5433-tmu.dtsi18 temperature = <65000>; /* millicelsius */
23 temperature = <70000>; /* millicelsius */
28 temperature = <75000>; /* millicelsius */
33 temperature = <80000>; /* millicelsius */
38 temperature = <85000>; /* millicelsius */
43 temperature = <90000>; /* millicelsius */
48 temperature = <95000>; /* millicelsius */
106 temperature = <65000>; /* millicelsius */
111 temperature = <70000>; /* millicelsius */
116 temperature = <75000>; /* millicelsius */
[all …]
A Dexynos7-trip-points.dtsi11 temperature = <75000>; /* millicelsius */
16 temperature = <80000>; /* millicelsius */
21 temperature = <85000>; /* millicelsius */
26 temperature = <90000>; /* millicelsius */
31 temperature = <95000>; /* millicelsius */
36 temperature = <100000>; /* millicelsius */
41 temperature = <110000>; /* millicelsius */
46 temperature = <115000>; /* millicelsius */
/linux/arch/arm/boot/dts/
A Dexynos5422-odroidxu3-common.dtsi147 temperature = <50000>;
152 temperature = <60000>;
157 temperature = <70000>;
167 temperature = <70000>;
172 temperature = <85000>;
220 temperature = <50000>;
225 temperature = <60000>;
230 temperature = <70000>;
240 temperature = <70000>;
245 temperature = <85000>;
[all …]
A Dexynos5422-odroidhc1.dts90 temperature = <70000>;
95 temperature = <85000>;
100 temperature = <120000>;
134 temperature = <70000>;
139 temperature = <85000>;
144 temperature = <120000>;
178 temperature = <70000>;
183 temperature = <85000>;
188 temperature = <120000>;
222 temperature = <70000>;
[all …]
A Dam57xx-industrial-grade.dtsi3 temperature = <90000>; /* milliCelsius */
7 temperature = <105000>; /* milliCelsius */
11 temperature = <105000>; /* milliCelsius */
15 temperature = <105000>; /* milliCelsius */
19 temperature = <105000>; /* milliCelsius */
23 temperature = <105000>; /* milliCelsius */
A Dam57xx-commercial-grade.dtsi3 temperature = <80000>; /* milliCelsius */
7 temperature = <90000>; /* milliCelsius */
11 temperature = <90000>; /* milliCelsius */
15 temperature = <90000>; /* milliCelsius */
19 temperature = <90000>; /* milliCelsius */
23 temperature = <90000>; /* milliCelsius */
/linux/Documentation/devicetree/bindings/hwmon/
A Dnuvoton,nct7802.yaml15 5 remote temperature sensors with SMBus interface.
54 - temperature
57 temperature-mode:
87 # temperature-mode to be set. Otherwise (for all other channels or
88 # sensor-type settings), do not allow temperature-mode to be set
99 - temperature
102 - temperature-mode
106 - temperature-mode
136 sensor-type = "temperature";
137 temperature-mode = "thermal-diode";
[all …]
A Dmax6697.txt24 Only valid for MAX6581. Set to enable extended temperature range.
25 Extended temperature will be disabled if not specified.
28 remote temperature channel 1.
32 Select bit 0 for local temperature, bit 1..7 for remote temperatures.
34 - over-temperature-mask
35 Over-temperature bit mask. Over-temperature reporting disabled for
37 Select bit 0 for local temperature, bit 1..7 for remote temperatures.
38 If not specified, over-temperature reporting will be enabled for all
42 cancellation on remote temperature channel 1.
63 over-temperature-mask = <0x7f>;
/linux/drivers/net/wireless/intel/iwlwifi/mvm/
A Dtt.c53 if (mvm->temperature == temp) in iwl_mvm_tt_temp_changed()
56 mvm->temperature = temp; in iwl_mvm_tt_temp_changed()
162 notif->temperature); in iwl_mvm_ct_kill_notif()
382 s32 temperature = mvm->temperature; in iwl_mvm_tt_handler() local
431 if (temperature < params->tx_backoff[i].temperature) in iwl_mvm_tt_handler()
464 {.temperature = 112, .backoff = 200},
465 {.temperature = 113, .backoff = 600},
611 int *temperature) in iwl_mvm_tzone_get_temp() argument
629 *temperature = temp * 1000; in iwl_mvm_tzone_get_temp()
666 s16 temperature; in iwl_mvm_tzone_set_trip_temp() local
[all …]
/linux/Documentation/devicetree/bindings/iio/temperature/
A Dmelexis,mlx90632.yaml4 $id: http://devicetree.org/schemas/iio/temperature/melexis,mlx90632.yaml#
7 title: Melexis MLX90632 contactless Infra Red temperature sensor
15 There are various applications for the Infra Red contactless temperature
17 measured object temperature is in range between -20 to 200 degrees
19 object temperature range for industrial applications. Since it can
20 operate and measure ambient temperature in range of -20 to 85 degrees
24 temperature. MLX90632 can be calibrated to reduce the housing effect via
28 emissivity should be set before requesting the object temperature.

Completed in 35 milliseconds

12345678910>>...30