| /linux/Documentation/admin-guide/pm/ |
| A D | intel_pstate.rst | 240 The P-states above the turbo threshold are referred to as "turbo P-states" and
264 be exceeded if a turbo P-state was used for too long.
280 The maximum supported turbo P-state, the turbo threshold (the maximum supported
310 * The maximum supported `non-turbo P-state <turbo_>`_.
312 * Whether or not turbo P-states are supported at all.
314 * The maximum supported `one-core turbo P-state <turbo_>`_ (if turbo P-states
365 inclusive) including both turbo and non-turbo P-states (see
390 default), turbo P-states can be set by the driver.
498 in the turbo frequency range.
629 benefit from running at turbo frequencies will be given non-turbo P-states
[all …]
|
| A D | intel-speed-select.rst | 155 speed-select-turbo-freq:disabled
216 workload, disable turbo::
277 speed-select-turbo-freq:disabled
281 speed-select-turbo-freq:disabled
551 that turbo is disabled. To disable turbo, execute::
745 Get Base turbo capability
759 turbo-ratio-limits-sse
831 speed-select-turbo-freq
872 turbo-freq
877 turbo-freq
[all …]
|
| /linux/Documentation/ABI/testing/ |
| A D | sysfs-platform-msi-laptop | 46 Contains either 0 or 1 and indicates if turbo mode is turned
47 on. In turbo mode power LED is orange and processor is
49 only possible to toggle turbo mode state by pressing Fn+F10,
51 If user presses Fn+F10 too frequent, turbo mode state is not
|
| /linux/Documentation/scheduler/ |
| A D | schedutil.txt | 64 4C-turbo; if available and turbo enabled
65 f_max := { 1C-turbo; if turbo enabled
72 We pick 4C turbo over 1C turbo to make it slightly more sustainable.
|
| /linux/Documentation/devicetree/bindings/opp/ |
| A D | opp-v2.yaml | 75 turbo-mode;
159 turbo-mode;
239 turbo-mode;
265 turbo-mode;
|
| A D | opp-v2-base.yaml | 125 turbo-mode:
127 Marks the OPP to be used only for turbo modes. Turbo mode is available
|
| /linux/arch/arm64/boot/dts/qcom/ |
| A D | sdm850.dtsi | 19 turbo-mode;
|
| /linux/arch/arm64/boot/dts/renesas/ |
| A D | r8a779m1.dtsi | 19 turbo-mode;
|
| A D | r8a779m3.dtsi | 19 turbo-mode;
|
| A D | r8a779m5.dtsi | 19 turbo-mode;
|
| /linux/drivers/misc/ |
| A D | xilinx_sdfec.c | 410 struct xsdfec_turbo turbo; in xsdfec_set_turbo() local
414 err = copy_from_user(&turbo, arg, sizeof(turbo)); in xsdfec_set_turbo()
418 if (turbo.alg >= XSDFEC_TURBO_ALG_MAX) in xsdfec_set_turbo()
421 if (turbo.scale > XSDFEC_TURBO_SCALE_MAX) in xsdfec_set_turbo()
428 turbo_write = ((turbo.scale & XSDFEC_TURBO_SCALE_MASK) in xsdfec_set_turbo()
430 turbo.alg; in xsdfec_set_turbo()
|
| /linux/drivers/net/wireless/ath/ath5k/ |
| A D | reset.c | 672 u32 turbo, mode, clock, bus_flags; in ath5k_hw_nic_wakeup() local
675 turbo = 0; in ath5k_hw_nic_wakeup()
792 turbo = AR5K_PHY_TURBO_MODE; in ath5k_hw_nic_wakeup()
794 turbo |= AR5K_PHY_TURBO_SHORT; in ath5k_hw_nic_wakeup()
825 ath5k_hw_reg_write(ah, turbo, AR5K_PHY_TURBO); in ath5k_hw_nic_wakeup()
|
| /linux/arch/arm/mach-pxa/ |
| A D | sleep.S | 115 @ ensure x1 for run and turbo mode with memory clock
127 @ note, turbo is not preserved over sleep so there is no
|
| /linux/arch/arm/boot/dts/ |
| A D | exynos4412-prime.dtsi | 16 /delete-property/turbo-mode;
|
| A D | omap34xx.dtsi | 76 turbo-mode;
|
| /linux/arch/powerpc/boot/dts/ |
| A D | klondike.dts | 166 turbo = "no";
196 turbo = "no";
|
| /linux/drivers/opp/ |
| A D | opp.h | 80 bool turbo; member
|
| A D | debugfs.c | 130 debugfs_create_bool("turbo", S_IRUGO, d, &opp->turbo); in opp_debug_create_one()
|
| A D | of.c | 860 new_opp->turbo = of_property_read_bool(np, "turbo-mode"); in _opp_add_static_v2()
907 __func__, new_opp->turbo, new_opp->rate, in _opp_add_static_v2()
|
| /linux/Documentation/userspace-api/media/dvb/ |
| A D | frontend-property-satellite-systems.rst | 74 In addition to all parameters valid for DVB-S, turbo code supports the
|
| /linux/arch/arm/mm/ |
| A D | proc-mohawk.S | 345 mrc p14, 0, r4, c6, c0, 0 @ clock configuration, for turbo mode
363 mcr p14, 0, r4, c6, c0, 0 @ clock configuration, turbo mode.
|
| A D | proc-xsc3.S | 416 mrc p14, 0, r4, c6, c0, 0 @ clock configuration, for turbo mode
434 mcr p14, 0, r4, c6, c0, 0 @ clock configuration, turbo mode.
|
| A D | proc-xscale.S | 532 mrc p14, 0, r4, c6, c0, 0 @ clock configuration, for turbo mode
548 mcr p14, 0, r4, c6, c0, 0 @ clock configuration, turbo mode.
|
| /linux/Documentation/input/devices/ |
| A D | bcm5974.rst | 19 :Copyright: |copy| 2005 Frank Arnold (frank@scirocco-5v-turbo.de)
|
| /linux/Documentation/devicetree/bindings/misc/ |
| A D | xlnx,sd-fec.txt | 25 - xlnx,sdfec-code : Should contain "ldpc" or "turbo" to describe the codes
|