Searched refs:nx_gpio_set_pull_mode (Results 1 – 6 of 6) sorted by relevance
| /u-boot/board/friendlyarm/nanopi2/ |
| A D | hwrev.c | 47 nx_gpio_set_pull_mode(__IO_GRP, gpios[i][0], 0); in bd_hwrev_config_gpio()
|
| A D | onewire.c | 241 nx_gpio_set_pull_mode(__IO_GRP, __IO_IDX, 2); in onewire_init()
|
| A D | board.c | 98 nx_gpio_set_pull_mode(gpio_a, i, 2); in bd_lcd_config_gpio()
|
| /u-boot/drivers/pinctrl/nexell/ |
| A D | pinctrl-s5pxx18.c | 65 static void nx_gpio_set_pull_mode(void *base, u32 pin, u32 mode) in nx_gpio_set_pull_mode() function
175 nx_gpio_set_pull_mode((void *)reg, pin, pinpud); in s5pxx18_pinctrl_set_state()
|
| /u-boot/arch/arm/mach-nexell/include/mach/ |
| A D | nx_gpio.h | 92 void nx_gpio_set_pull_mode(u32 module_index, u32 bit_number, u32 mode);
|
| /u-boot/arch/arm/mach-nexell/ |
| A D | nx_gpio.c | 282 void nx_gpio_set_pull_mode(u32 module_index, u32 bit_number, u32 mode) in nx_gpio_set_pull_mode() function
|
Completed in 24 milliseconds